Simulation not reset
Error ID: 4001
Platform: Process Simulate
This message appears when attempting to import resolver results while the simulation is either currently running or not positioned at the start. The system needs the simulation to be stopped and rewound to ensure imported paths are applied correctly. If the user clicks "Yes", the simulation will be stopped and rewound automatically. If the user clicks "No" or cancels, the import operation is aborted and the user must manually reset the simulation before trying again.
What this error means
- Severity: Question
- Blocking behaviour: question
- Dialog type: Question (Yes/No buttons)
- The message indicates that Resolver found an issue with the current Process Simulate setup and is warning you before continuing with the export/import workflow.
Dialog text shown in Resolver
Simulation reset required. Move to start?
How to fix it (step-by-step)
- Carefully read the dialog text shown above and note any robots, operations, objects, or settings that are mentioned.
- In Process Simulate, inspect the affected station or operation and verify that the setup matches the expectations described in the message (for example: targets, robots, kinematics, collision sets, RCS configuration, export options, cloud settings, etc.).
- Decide whether it is safe to continue based on your project phase. If in doubt, cancel the operation, fix the root cause in Process Simulate, and then retry.
- Save your changes in Process Simulate and run the Resolver import/export again.
- Confirm that the message no longer appears, or that it now reflects the updated configuration correctly.